Seems pretty elementary doesn't it? What should be a simple safety check on fossil fuel burning appliances, particularly for boilers with regards to ease of inspection, often is assumed with complacency or even goes unchecked. I know everyone's maintenance schedule is packing up in the Northeast with the cold snap this week, so Technicians Take Heed!

There are many indicators that should trigger the phrase: "Check the flue!" I always measured the draft in the flue of a natural draft, 80% appliance. Too high or too low of a draft both can be an issue. HVAC Contractors tend to focus on the 'too little draft' by installing chimney liners, completing Combustion Appliance Zone and CO testing. Of course, this condition could be the most dangerous, so I can't blame them. Who ever expects to pull the flue off the boiler, look into the chimney and see what is pictured? There must have been 40 years of garbage piled up! Really is a spectacular thing that after all the years of maintenance I have yet to become complacent with the Flue.

Did you know the draft of the chimney is very dependent on the temperature difference between the flue gas and outside? The greater the temperature difference, the better the draft (generally speaking). This means the draft may be just fine on a cold Winter night, yet spill gases on a warm Fall afternoon.

Conversion warning: 25 Pascals = .10" w.c. I know: metric, really?...Trust me, the rest of the world has the real gripe when they see standard measurements. I bet your electronic manometers or even magnahelics (whatever you are using for draft measurements) have this scale.

Take a look at this chart supplied by Building Performance Institute (T_Out is your Outdoor Ambient Temp), start testing, and be sure that boiler will be safe all year long. Oh, and don't forget about the water heater too!

BPI.org

The draft was just fine on this older, larger than most boilers (-.03"w.c.). Except how long before that chimney became a real problem? I have to tell everyone: I have found birds, nests, even a squirrel in a 90%+ flue. Yes, that was a rotting mess to cut through with a hacksaw in a half-finished basement. Always test the draft, measure the CO, and look into the flue/chimney. You may just be surprised one day; possibly save someone, or maybe a home!